Workstation for DOS ODI Client Introduction: ------------- This document describes the procedure to setup the NetWare v3.X , v4.X workstation driver for Genius LAN GE2500III PCI ethernet adapter. Location of Driver: \NETWARE\DOSODI\PCIODI.COM Sample Configuration Files: --------------------------- STARTNET.BAT: LSL PCIODI IPXODI NETX or VLM (VLM's for NetWare 4.x ) NET.CFG LINK DRIVER PCIODI FRAME ETHERNET_802.3 EtherID 0123456789AB ------> This keyword is Ethernet address of a adapter, and only required when more than one GE2500III adapters exist on one system Setup Procedures for NetWare 3.11/3.12 Client : ----------------------------------------------- Before you start with the installation process, make sure that the adapter is properly installed and configured. Make sure that your NetWare workstation is properly installed. 1. Copy PCIODI.COM from the Genius LAN GE2500III Driver Diskette subdirectory A:\NETWARE\DOSODI to your harddisk. 2. Create a batch file, or add to your STARTNET.BAT file the commands listed above under STARTNET.BAT 3. Edit the NET.CFG file that you copied over. Edit the file per your requirements (see examples above). If there are two frame types listed, whichever frame type is listed first, that is the one that the driver will load. See above for examples. The NET.CFG file should be in the same directory with the LSL.COM file. Setup Procedures for NetWare 4.X Client with vlm: ----------------------------------------------- The installation utility INSTALL.EXE is located on NetWare's "Workstation for DOS" disk. Run INSTALL.EXE from the Workstation for DOS Disk. The NetWare Client Install program screen will appear. You must complete each of the questions. These options are specific to your needs. 1. Enter the destination directory for the NetWare Client. (The default directory is C:\NETWARE\DOSODI). 2. Gives you the option to automatically update the CONFIG.SYS and the AUTOEXEC.BAT files or modify them at a later time manually. 3. Do you wish to install support for MS Windows ? (Y/N) (MS Windows Subdirectory: default C:\WINDOWS) 4. Asks you to select a network driver and provide configuration options. It uses the specifications you select to create the file NET.CFG. Insert the Genius LAN GE2500III drivers disk when prompted for the driver disk and specify the driver path A:\NETWARE\DOSODI 5. Press <Enter> to install NOTE: ----- 1. Be sure to add LASTDRIVE=Z to your CONFIG.SYS file for the network mappings to work properly. 2. Installing Multiple LAN Adapters: The keyword, EtherID, is provided for multiple LAN adapters in a single system by PCIODI.COM. If EtherID unknown, you can ignore it on the NET.CFG file and directly run PCIODI under the DOS prompt,then your screen will display every adapter EtherID and select which one you need.
ekobudowa