hc5500_hc5700_int.pdf

(2079 KB) Pobierz
PrecisionCut Hair Clipper
HC5500
HC5700
ENGLISH
Thank you for buying your new Remington® product. Please read these
instructions carefully and keep them safe. Remove all packaging before use.
F
IMPORTANT SAFETY INSTRUCTIONS
WARNING – TO REDUCE THE RISK OF BURNS, ELECTROCUTION, FIRE OR INJURY
TO PERSONS:
1 This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been supervised/instructed and
understand the hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be done by children unless they are
older than 8 and supervised. Keep the appliance and cable out of reach of
children under 8 years.
2 The adaptor contains a transformer. Do not cut off the adaptor to replace it
with another plug, as this causes a hazardous situation.
3 Use this appliance only for its intended use as described in this manual. Do
not use attachments not recommended by Remington®.
4 Do not use this product if it is not working correctly, if it has been dropped or
damaged, or dropped in water.
5 This appliance should never be left unattended when plugged into a power
outlet, except when charging.
6 Keep the power plug and cord away from heated surfaces.
7 Do not immerse the appliance in liquid; do not use it near water in a
bath-tub, basin or other vessel; and don’t use it outdoors.
8 Make sure the power plug, cord and product unit do not get wet.
9 Do not plug or unplug the appliance with wet hands.
10 Do not immerse in water or any other liquid. Do not rinse under a tap.
11 Do not reach for an appliance that has fallen into water. Unplug it
immediately.
12 Always place and use that appliance on a surface that is fluid-resistant.
13 Always put the headguard on the product to protect the cutting heads whilst
travelling.
14 Do not use the appliance, adaptor or any other part if it is damaged, as this
may cause injury. Always replace a damaged adaptor with one of the original
type.
15 Do not twist or kink the cable, or wrap it round the appliance.
16 Charge, use and store the product at a temperature between 10°C and 35°C.
17 This appliance is not intended for commercial or salon use.
18 WARNING: Keep the appliance dry.
2
ENGLISH
D
AE
3
19
HC5500: This appliance should be supplied with approved safety
isolating adaptors PA-3215E (for EU), PA-3215U (for UK) with the output
capacity of 3.2Vdc; 1500mA (adaptor output).
HC5700: This appliance should be supplied with approved safety
isolating adaptors PA-4515E (for EU), PA-4515U (for UK) with the output
capacity of 4.5Vdc; 1500mA (adaptor output).
2
4
8
1
5
6
C
KEY FEATURES
1
2
3
4
On/Off/Turbo Switch
Blade set
2 attachment guide combs
1-21mm and 24-44mm (not shown)
Blade release button
5
6
7
8
Charging indicator light
Micro USB port
Adaptor (not shown)
Slide select adjustable comb switch
UA
HR
SI
GR
RO
TR
RU
HUN
PL
CZ
SK
P
FIN
S
DK
I
E
F
NL
GB
ENGLISH
C
GETTING STARTED
,
CHARGING YOUR APPLIANCE
•
Before using your hairclipper for the first time, charge for 14-16 hours
(HC5500) and 4 hours (HC5700).
• Ensure the product is switched off.
• Connect the charging adaptor to the product and then to the mains.
• If the product is not going to be used for an extended period of time (2 – 3
months), unplug it from the mains and store.
• Fully recharge your hairclipper when you would like to use it again.
• Allow for 14-16 hours for a full charge for HC5500 and 4 hours for HC5700.
• HC5500: when charging the LED indicator will be illuminated and will remain
illuminated once the product is fully charged.
• HC5700: when charging the LED indicator will be illuminated and will turn
off once the product is fully charged.
• To preserve the life of your batteries, let them run out every 6 months then
recharge for 14-16 hours.
• The HC5700 comes with a quick charge function, 10 minutes charging will
give an emergency burst of run time.
,
CHARGING VIA STANDARD ELECTRICAL SOCKET
•
Ensure the product is switched off.
• Connect the charging adaptor to the product and then to the mains.
,
USB
• Connect Micro USB to the appliance, and the USB connector to any standard
USB port or charger.
• Product will only charge through USB and will not run in corded mode.
,
CORDED USE
•
Connect the charging adaptor to the product then to the mains.
,
CAUTION
• Extended mains only use will result in the reduction of the battery life.
,
CORDLESS USE
•
When the unit is switched on and fully charged, the product can be used in
cordless mode for up to 60 minutes for the HC5500 and up to 75 minutes for
the HC5700.
4
ENGLISH
D
,
•
•
•
BEFORE STARTING THE CUT
Inspect the clipper making sure that it is free from hair and dirt.
Seat the person so that their head is approximately at your eye level.
Before cutting, always comb the hair so it is tangle free and dry.
2mm
3mm
4mm
5mm
6mm
9mm
12mm
15mm
18mm
21mm
25mm
26mm
27mm
28mm
29mm
32mm
35mm
38mm
41mm
44mm
AE
5
UA
HR
SI
GR
RO
TR
RU
HUN
1mm
24mm
PL
Shorter Length
Adjustable Comb
Longer length
Adjustable Comb
CZ
,
HAIR CLIPPER COMB SETTINGS
•
The clipper comes with two adjustable combs, a short length adjustable
comb (indicated by 1-21mm on the back of the comb) and a longer length
adjustable comb (indicated by 24-44mm on the back of the comb).
• Please see table below for different cutting lengths available on each comb:
SK
P
FIN
,
TO ATTACH A COMB
•
Hold the comb with its teeth upward.
• To attach a comb, align the legs of the comb with the holes in the top of the
clipper on each side of the blade and slide the legs into the trimmer until
they click.
• To remove, firmly pull the comb straight up away from the clipper.
S
DK
I
E
F
NL
F
INSTRUCTIONS FOR USE
GB

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika:

Zgłoś jeśli naruszono regulamin